DESCRIPTION

The Mini ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 micro controller families.
The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 micro controller.
Fully compatible with ST version, including automatic firmware updates.

Device Pin-OUT

The pin-out of this model is:

1. RST
2. SWDIO
3. GND
4. GND
5. SWIM
6. SWCLK
7. 3.3V
8. 3.3V
9. 5.0V
10. 5.0V

Compatible with the following environments:

• ST -LINK Utility 2.0 and higher

• STVD 4.2.1 and higher

• STVP 3.2.3 and higher

• IAR EWARM V6.20 and higher

• IAR EWSTM8 V1.30 and higher

• KEIL RVMDK V4.21 and higher

Detail

Compatible with automatic updates of the firmware, firmware version installed : V2.J17.S4 or major
Compatible 5V
Interface standard 10 pin 2.54mm
Housing Aluminium

Use the administrator mode to install the driver on Vista, WIN7 , WIN8
Device Manager will show " STMicroelectronics STLink dongle " from the successful installation.
Please open driver and code by administrator mode in WIN WISTA/WIN 7/WIN 8 system.if display "STMicroelectronic STLink dongle" in device manager,that is say install success.